RS232 Serial Communication Setup for Fanuc 10/ 11/ 15 controls

Personal Computer Settings
4800 Baudrate
2 stop bits
ISO Code (ASCII)
Even parity
Data length = 7 bits
Control Codes (Xon/ Xoff used)
LF for End Of Block

RS232 serial communication parameters for Fanuc 10/ 11/ 15

SETTING PAGE

PUNCH CODE = 0 0:ISO 1:EIA

INPUT DEVICE = 1 or 2

OUTPUT DEVICE = 1 or 2

For Fanuc 10/ 11 control: Set INPUT/OUTPUT DEVICE to 1 if RS232 is connected to MDI/CRT board
Set 2 if RS232 is connected to master PCB (10/11 control)

For Fanuc 15 control: Set INPUT/OUTPUT DEVICE to 1 if RS232 is connected to connector CD4A of Base 0 PCB
Set 2 if RS232 is connected to connector CD4B of Base 0 PCB

PARAMETER
0000 = 00000000
5001 = 1 (WHEN INPUT DEVICE = 1)
5002 = 1 (WHEN INPUT DEVICE = 2)
5110 = 3
5111 = 2
5112 =10

Baud rate         Setting on PRM 5112
50                               1
100                             2
110                             3
150                             4
200                             5
300                             6
600                             7
1200                           8
2400                           9
4800                          10
9600                           11