KFAS: Fanuc CNC Parts, Service, & Repair

K Factory Automation Services has large inventory of Fanuc parts in stock and we maintain a full service in-house repair facility.

SV0606, SP9113 alarm on Fanuc 30iB control with Alpha i-B amplifiers (Fanuc Manual B-65285EN)

Alarm Code 10 (SV0606, SP9113)
(1) Meaning
The heat sink cooling fan has stopped.
(2) Cause and troubleshooting
(a) Failure in the heat sink cooling fan
Check the rotation state of the heat sink cooling fan.
→ Replace the heat sink cooling fan.
(b) The control printed circuit board is not correctly attached.
→ Push in the control printed circuit board in the front section of the Power Supply as far as it
will go. If it does not go in easily, pull it out and then push it in again.
(c) The Power Supply is defective.
→ Replace the Power Supply.

SV0606, SP9113 (Fanuc Manual B-65285EN)

This alarm is applicable for the following units

A06B-6200-H003 αiPS 3-B
A06B-6200-H008 αiPS 7.5-B
A06B-6200-H011 αiPS 11-B
A06B-6200-H015 αiPS 15-B
A06B-6200-H026 αiPS 26-B
A06B-6200-H030 αiPS 30-B
A06B-6200-H037 αiPS 37-B
A06B-6200-H055 αiPS 55-B

A06B-6202-H003 αiPS 3-B
A06B-6202-H008 αiPS 7.5-B
A06B-6202-H011 αiPS 11-B
A06B-6202-H015 αiPS 15-B
A06B-6202-H026 αiPS 26-B
A06B-6202-H030 αiPS 30-B
A06B-6202-H037 αiPS 37-B
A06B-6202-H055 αiPS 55-B

© Copyright KFASLLC Houston, Texas, USA